With the limit switches working, it was time to tackle the spindle control. The spindle is normally controlled with on/off switches and a speed knob on the spindle itself, but for CNC use it’s useful to have the ability to run the spindle from the G-code. I ordered a “CNC spindle control kit” with the …
Continue reading ‘CNC Mini Mill #9: Spindle and coolant control’ »
One of the remaining things to hook up to the mill were the limit switches. This has taken forever, but I was waiting on some shielded 2-conductor wire I ordered on ebay. It arrived a few days before Christmas, so now it was time to check that item off the list. I briefly talked about …
After talking about the ill-fated Arduino shields, here’s something more pedestrian. Whenever I’ve used the mill, I get chips everywhere and they get dragged into the house. It also feels a bit sketchy using the Superfly cutter without any kind of protection, since if the insert holder were to come loose it would go flying …
Continue reading ‘CNC Mini Mill #7: Another kind of shield’ »
In the post that talked about how I burned out the Arduino, I concluded with the need for a dedicated 48V-to-12V converter that would supply power to the Arduino but also to the coolant solenoid and various other things that might need 12V. Unfortunately a switching buck converter is a bit more complicated than just …
In the previous post I talked about how the mount for the X-axis stepper motor in the CNCFusion kit didn’t line up the motor with the ballscrew axis. I realized that the clearest way of showing this was to bolt the motor mount directly to the thrust bearing mount. Any misalignment should then be obvious. …
Continue reading ‘CNC Mini Mill #5: Correcting the X-axis’ »
In the previous posts I described the electronics box and motion controller. (Newsflash: The Arduino Due survived! There was only a shorted input capacitor. When I removed that, it worked again, and I so far haven’t found anything that’s really broken. Amazing, dodged another bullet there.) This post will focus on the physical mill setup. …
The last post explained what the motion controller needs to do. This post will deal with the actual assembly of the electronics. The G251X motor controllers can run up to 50V, and higher voltage makes higher speeds possible (you need the higher voltage to counter the back emf from the motors, which gets higher the …
The last post described the physical setup of the mini mill CNC conversion. Apart from adding motors to the mill, you also need something to control those motors. Most people seem to just get a G540 motor controller from Geckodrive and hook it up to the Mach3 CNC software. This seems to be a nice “turnkey” solution …
As mentioned over the last few posts of the NC30 EFI project, I’m going to need to fabricate various little metal parts. That’s not something that I’ve had the capability of doing here. Back when I got the ShapeOko, I was hoping it was going to be able to do light aluminum work. While I …
Since we moved here, I’ve constantly been annoyed whenever I’ve tried to find tools or other specific things because nothing was organized. Some things were in the basement, some things in the garage, some things in unopened moving boxes, and it was impossible to find anything. I’ve probably spent more time looking for tools than …