One thing we had decided that we definitely wanted to do back before we put in an offer on the place was to open up the tiny doorway between the kitchen and living room. The kitchen felt really closed in, and the living room had this long interior wall. By opening up the doorway, we’d …
Finally, we’re getting to the end of the floor story. With the floors sanded, it was time to apply finish. We (or really, I) spent many hours trying to figure out what kind of finish to use. There are many choices, oil-based or water-based, cheap or expensive, etc. Given the amount of work we had …
There’s been a while since the last episode of the whirlwind month of work after we moved in. That’s because, can you imagine, the work has just continued… Anyway, when we ended, we were just about to go pick up my Dad at the airport and start sanding the floors. We were going to rent …
While all traces of the carpet in the other rooms got ripped out in less than two days, it took about a week to get it all out from the kitchen. This had to be done in stages. First, the carpet was ripped up. However, since the carpet was glued to the floor (as seen …
Continue reading ‘Floor refinishing #2 – the joys of methylene chloride’ »
We moved in at the end of October, and the absolutely imperative task #1 to accomplish was to rip out the atrocious carpets that covered the hardwood floors. We had already scoped out the floors when we first looked at the place because, honestly, if it hadn’t had those wood floors underneath we would have …
… and we are back online after the move to Hawaii! Expect many home improvement updates soon.
This may be a more pedestrian project, but it looks like I’m going to have to do some home improvement. Unless we hit some unforeseen snag, this will be our new home in Hawaii: It needs a bit of work, so the next few projects will probably have to do with things like installing a …
I don’t think anyone’s noticed, but I figured I should mention something for posterity: Plane work has come to a temporary stop. Early this summer we found out that we will be moving from LA to Hawaii this fall so Kathy can start her new job as Professor of Astronomy at University of Hawaii, Hilo! …
I finally got a rear stand for the NC30 so I could take a look at the rear wheel. Since it has a single-sided swingarm, you need a stand that has a big fat pin that’s inserted into the rear hub, and it turns out those stands are a) much more expensive than normal two-sided …
If you’ve read the the clutch posts #1 and #2, you know that I’ve been trying to get the clutch sorted for a while. The latest state of affairs was that the clutch was slipping uncontrollably and I’d then realized my clutch had NC35 pressure plates, which are 1.9mm thick instead of 1.5mm. So I …